raspberry pi

STEVE – New chassis, 3D printing, fresh electronics!

IMG_20151122_133544Plenty has happened since our last post, and most of it can be summarized with the following picture.

Yup, lots of wires. New body, too. With my 3D printer back in service, cases were printed for the electronics, along with new wheels all around. These new wheels add around an inch of ground clearance, and better off-road traction.

As well, the first shipment of new parts has arrived: a USB WiFi adapter, an ultrasonic range sensor, H-Bridge motor controller, 9-DOF IMU and a temperature probe.

There are a lot of really cool developments in this post; let’s dive in.

› Continue reading

Tags: , , , , , ,

Saturday, December 12th, 2015 3d printing, electronics, networking, software, steve No Comments


20151103_223737He may not look like much right now, but STEVE is an evolving project I’ve been wanting to start for quite some time. He is a robot, into which I will combine software, hardware, and mechanical design.

Currently STEVE is an AVR microcontroller and LM298 dual motor driver, strapped to a circa 1985 remote control car. Over the last few days, I began laying the foundation with serial communication, motor control, and power. In the next few weeks, I should receive the first order of parts to give STEVE senses.

Initial Sensors:20151103_223750

  • Ultrasonic range sensor
  • 9-Degrees-of-freedom Intertial Measurement Unit (with compass)
  • DS18B20 Temperature Sensor
  • USB WiFi Adapter
  • LM298 Motor Driver (a better unit)

Once progress is made with these first parts, I also plan on including these additional sensors:20151103_223743

  • GPS
  • Servo (to pivot ultrasonic range sensor)
  • Current Sensing
  • Webcam

This is a great wish list, but without the software to tie it all together, not very useful. Therefore, I’m assigning my Raspberry Pi 2 B+ as STEVE’s brain. My vision is for the Pi to do all the heavy processing such as navigating, making 20151103_223817decisions, and hosting the user interface for mission planning. That way, the AVR is only a hardware controller that manages Input/Output, and communicates bi-directionally with the Pi.


Over the last week the project has evolved very rapidly, and a new body is in the works. My 3D printer has some serious overtime coming up, as I begin designing and printing STEVE’s mechanical components. The ability to print new wheels, mounts, gears and body components is critical to the success of this project, and will also mean I can be very flexible with how everything is implemented.

I have a lot of freedom to do really cool things with this, and I look forward to posting regular updates on STEVE’s progress here!

Tags: , , ,

Sunday, November 8th, 2015 electronics, projects, software, steve No Comments