resistor

Denon AVR-1801 – Blinking Red Light Repair

IMG_20150820_103928The other day, my Denon AVR-1801 home theater receiver stopped working. It would power on, reach the point where it normally enabled the speaker outputs, but then it would shut off. The status LED would rapidly blink on and off.

The user manual suggested that the device was overheating, or that the speaker terminals were being shorted. The device was not hot, as it was just turned on. I unplugged all input and output cables, but that didn’t fix it either. Time to dig deeper.

 

The Problem

A quick Google search revealed the following gem. There are four “surge” resistors in line with the ±15 VDC regulators: R141, 142, 148, 149. These 1 Ohm resistors weaken over time with every power-on surge, and the resistors from the factory were not strong enough. Armed with this knowledge, I opened my receiver to test these resistors.

› Continue reading

Tags: , , , , ,

Thursday, August 27th, 2015 electronics 1 Comment